Greenhouse Mapping

16 November 2026

Double-poly vs single-layer film: what the air gap tells you about heating demand

How to tell double-poly inflated roofs from single-layer film in protected cropping, and why that difference drives heating fuel and blower demand.

Close-up of an arched greenhouse roof showing ribbed polyethylene film panels and support framing in daylight.

If you're sizing territory for heating fuel, blower motors, or replacement film, the roof covering on a greenhouse tells you more than square footage ever will. Two houses with identical footprints can carry very different input loads depending on whether the grower is running a single sheet of poly or a double layer held apart by an air gap.

Single-layer film vs double-poly: what's actually different

Single-layer film is one sheet of polyethylene stretched over the hoops. It's the cheapest covering to install, it transmits a bit more light, and it gives almost no insulating value beyond the plastic itself. Heat moves through it fast, so a single-layer house in a cold climate runs its heaters hard, especially overnight.

Double-poly is two layers with a blower running between them, holding a pocket of air that acts as the insulating layer. That gap is the whole point. Still air is a poor conductor, and a few inches of it between two films cuts heat loss meaningfully compared to a single sheet. Growers who run double-poly in cold or shoulder-season climates are trading a bit of light transmission and a continuous blower load for lower heating bills over the season.

For an input supplier, that trade shows up as two different demand profiles on your territory map: single-layer houses that lean hard on propane, natural gas, or biomass boilers, and double-poly houses that lean on the blower plus a smaller heating load.

Spotting the covering from above

From a high-resolution pass, the two roof types read differently even without walking the row. A double-poly roof holds its shape, taut and slightly domed between the hoops because of the constant air pressure from the blower. Single-layer film sags and ripples more, especially as it ages and stretches, and it catches light unevenly compared to the smoother double-skin surface. Structure age matters here too. Film degrades under UV over time regardless of which covering type it is, so a territory with a lot of older single-layer stock is also a territory due for a recover cycle, which is its own input event.

This is the kind of classification work that's hard to do at scale by driving routes. A field team can confirm covering type house by house, but confirming it across a few hundred structures spread over a county takes a crew weeks, and by the time they're done, some of what they logged in January has already changed. Annual imagery gives you a standing inventory instead: every structure in the region, sized and classified by type, refreshed on a cadence rather than chased down one grower relationship at a time.

Why the blower matters for your demand estimate

The air gap isn't passive. It needs a small blower running near-continuously to keep the two layers apart, and that blower draws power every hour the house is covered, independent of outdoor temperature. If you're an electrical contractor, an equipment distributor, or a utility planner working out load across a greenhouse cluster, double-poly structures add a baseline electrical draw that single-layer houses simply don't have. Count the double-poly roofs in a territory and you've got a rough floor for blower-related demand before you even get into seasonal heating variation.

Put the two pieces together, covering type and structure footprint, and you get a usable proxy for heating demand across a region without a single site visit: single-layer square footage points toward heating fuel volume, double-poly square footage points toward blower electrical load plus a smaller fuel component. Neither number replaces a conversation with the grower about their actual boiler and thermostat settings, but it gets you from zero to a defensible starting estimate for a whole territory, which is usually the hard part when you're planning input volumes before the season starts.

Greenhouse Mapping builds that structure-level inventory from imagery each year, classifying covering type and footprint across a region so you're not estimating heating and blower demand from a handful of site visits. If you've got a territory to size, that's the starting point.

Start a project

← Back to the blog