26 October 2026
Multi-span greenhouse or gutter-connected range? Reading the roofline
How to tell a gutter-connected range from standalone multi-span greenhouse blocks using ridge spacing, roof continuity, and vent lines in satellite imagery.

Field crews can walk a boundary and call a structure type by eye in five seconds. From a satellite pass, the same call takes a bit more pattern reading, and the terms "multi-span" and "gutter-connected" get used loosely enough in the trade that it's worth being precise before you build a territory count on top of them.
The terms, used precisely
A multi-span house is any structure built from repeated structural bays, each with its own ridge and gutter line, sharing side walls with the next bay over. A gutter-connected range is a multi-span house where the gutters tie every bay into one continuous roof and one continuous climate zone, no gap, no separate wall between bays. Every gutter-connected range is multi-span. Not every multi-span block is gutter-connected. Some growers run separate multi-span units side by side with a service path between them, and that reads very differently in imagery than one unbroken roof.
The distinction matters past semantics. A continuous gutter-connected range usually points to pad-and-fan or hot-water climate control, a crop on a longer calendar, and an input order built around one zone rather than several smaller ones. A row of detached multi-span blocks suggests a grower who scaled by bolting on units over time, which often means older glazing on the first block and newer film or glass on the later ones.
What to look for in the image
Three things carry most of the signal at 0.5-2 m resolution.
Ridge spacing. Each span throws a thin, regular line, visible in RGB as a tonal break and often sharper in NIR, since the ridge cap and panel pitch reflect differently from the surrounding roof. Count the lines and you get bay width. Bay widths under 7-8 m with a shallow, repeated saw-tooth pattern usually mean glass venlo construction; wider bays with a flatter roof profile usually mean film-clad multi-span.
Footprint continuity. This is the real test for gutter-connected status. Trace the outer wall line. If it runs unbroken around the full rectangle with no interior gap or access alley, that's one gutter-connected range, no matter how many ridge lines cross it inside. If a strip of bare ground or a service road cuts between blocks sharing the same ridge pattern, those are separate multi-span structures, and a territory count should list them as separate units even when they sit on one farm.
Vent lines and glare. Continuous roof vents on a gutter-connected range show up as a thin stripe running the length of the ridge, consistent across every bay because the vents went in as one system. On adjoining but separate multi-span blocks, vent alignment often shifts slightly from one block to the next, built or retrofitted on different schedules. Glass ranges also throw a uniform specular glare pass to pass, whereas film tends to show patchier reflectance as plastic ages and degrades unevenly across a roof.
Where this gets harder
None of that replaces a ground check. Film houses with shade cloth draped over the ridge can mask the saw-tooth pattern entirely, and a gutter-connected range with partial re-roofing can throw a footprint that reads as two structures when it's operated as one. Single-span tunnels and hoop houses are the easier call. They sit narrower, usually under 10 m, with a smooth curved roof and visible gaps between units, nothing like the repeated ridge geometry of a multi-span block.
For a planner sizing a whole territory rather than ground-truthing one farm, the useful output isn't a confident label on every roof. It's a structure-by-structure footprint and a best-fit type call, run the same way at the same resolution every year, so this year's gutter-connected count is comparable to next year's rather than redrawn from scratch by a different field crew.
That's the annual inventory Greenhouse Mapping builds from high-res satellite passes: every protected structure in a region, sized and typed, refreshed once a year.
If you're pricing a region's input demand by structure type, it's worth starting from a map that's already sorted the roofs.